English
Español 
Português 
русский 
Français 
日本語 
Deutsch 
tiếng Việt 
Italiano 
Nederlands 
ภาษาไทย 
Polski 
한국어 
Svenska 
magyar 
Malay 
বাংলা ভাষার 
Dansk 
Suomi 
हिन्दी 
Pilipino 
Türkçe 
Gaeilge 
العربية 
Indonesia 
Norsk 
تمل 
český 
ελληνικά 
український 
Javanese 
فارسی 
தமிழ் 
తెలుగు 
नेपाली 
Burmese 
български 
ລາວ 
Latine 
Қазақша 
Euskal 
Azərbaycan 
Slovenský jazyk 
Македонски 
Lietuvos 
Eesti Keel 
Română 
Slovenski 
मराठी 
Srpski језик
Talking about the way of cleaning dust in incinerator
2022-04-14
Low-temperature magnetization furnace incinerator steel ball ash cleaning is to use a crane to transport the steel balls to the top of the waste heat boiler, and then spread the steel balls from top to bottom. The ash and slag are removed by jumping and colliding between the steel balls in the heating surface tube, the falling ash is carried away by the flue gas, and the steel balls fall into the steel ball collection device arranged at the bottom of the waste heat boiler.
The steam soot in the low temperature magnetization furnace incinerator uses a certain pressure and dry steam as the soot blowing medium. Through the blowing nozzle, the steam has a certain kinetic energy, and the heating surface attached by the ash is directly blown off by the spray. The steam soot blowing has the characteristics of high pressure of the soot blowing medium and high jet velocity. It can quickly blow ash away from the heating surface, with strong slagging and low ash melting point, so it is widely used in modern boilers, but the high-speed jet of steam will wear the heating surface of the waste heat boiler, so it must be Take certain protective measures. At the same time, using steam as the soot blowing medium, steam injection will increase the moisture in the flue gas, which is easy to cause corrosion and ash on the heating surface of the waste heat boiler tail. At the same time, the use of steam also increases the cost of the waste heat boiler make-up water and water treatment.
The steam soot in the low temperature magnetization furnace incinerator uses a certain pressure and dry steam as the soot blowing medium. Through the blowing nozzle, the steam has a certain kinetic energy, and the heating surface attached by the ash is directly blown off by the spray. The steam soot blowing has the characteristics of high pressure of the soot blowing medium and high jet velocity. It can quickly blow ash away from the heating surface, with strong slagging and low ash melting point, so it is widely used in modern boilers, but the high-speed jet of steam will wear the heating surface of the waste heat boiler, so it must be Take certain protective measures. At the same time, using steam as the soot blowing medium, steam injection will increase the moisture in the flue gas, which is easy to cause corrosion and ash on the heating surface of the waste heat boiler tail. At the same time, the use of steam also increases the cost of the waste heat boiler make-up water and water treatment.
The above is the introduction to you about the ways of cleaning dust in incinerators. Do you have a better understanding of it after reading it? See you next time!
Previous:How cooling towers work
X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies.
Privacy Policy